Sunroof Seal/Molding Replacement ZRX/XTREME w/ CF5
Removal Procedure
- Remove the sunroof window. Refer to
Sunroof Window Replacement
.
- Remove the seal (2) from the front of the upper frame by pulling
upward on the seal.
- Finish removing the seal from the rear of the mainframe.
- Completely clean the channel in the mainframe of silicone adhesive and
any other debris. A nylon glazing stick or a soft wire brush would be helpful in removing
the silicone.
Installation Procedure
- Apply black, non-corrosive silicone adhesive
under the entire outside edge of the seal.
- Insert the new window seal by pressing the seal into the mainframe channel (3).
Use a roller-type tool on the seal to aid in the installation of the seal into the
channel.
- Install the sunroof window. Refer to
Sunroof Window Replacement
.
- Fully close the sunroof and wait 4-6 hours for the silicone to dry.
- Visually inspect the window and seal in the full open and
closed positions.
- Open the sunroof.
- Inspect the seal for high spots, correct if needed.