Sunroof Module Assembly Replacement CF5

1. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.



2. Remove the sunroof drain hoses from the sunroof assembly. Refer to Sunroof Housing Front Drain Hose Replacement and Sunroof Housing Rear Drain Hose Replacement .
3. Disconnect the electrical connectors.



4. Remove the bolts that retain the sunroof module assembly to the roof.
5. Release the retainers that secure the sunroof module assembly to the roof.
6. With an assistant, remove the sunroof module assembly from the vehicle.

1. Install 2 nuts on the roof bow and a nut to each side rail.
2. With an assistant, position the sunroof module assembly to the roof.



3. Use the sunroof retainers in order to secure the sunroof module assembly to the roof.

The sunroof retainers are used in order to assist in the assembly of the sunroof module assembly at the assembly plant. If a retainer is broken, do not replace the retainer.

4. Ensure that all broken retainer pieces are removed from the vehicle in order to prevent a rattle noise.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the bolts that retain the sunroof module assembly to the roof.

Tighten
Tighten the sunroof module assembly mounting bolts to 9 N·m (80 lb in).

6. Install the sunroof drain hoses to the sunroof module assembly. Refer to Sunroof Housing Front Drain Hose Replacement and Sunroof Housing Rear Drain Hose Replacement .
7. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
8. Perform the following steps in order to adjust the sunroof window, as needed:

8.1.	Loosen the screws that retain the sunroof window to the sunroof module assembly.

8.2.	Adjust the fit between the sunroof window and the roof opening.

The fit should be equal on both sides.

8.3.	Adjust the rear edge of the window slightly higher than the front edge in order to minimize wind noise.

8.4.	Secure the sunroof window in position by tightening the screws.

Tighten
Tighten the screws to 3.5 N·m (31 lb in).

9. Open and close the sunroof.
10. Inspect the fit of the sunroof window.