The wide band heated oxygen sensor (HO2S) measures the amount of oxygen in the exhaust system and provides more information than the switching style HO2S. The wide band sensor consists of an oxygen sensing cell, an oxygen pumping cell, and a heater. The exhaust gas sample passes through a diffusion gap between the sensing cell and the pumping cell. The engine control module (ECM) supplies a voltage to the HO2S and uses this voltage as a reference to the amount of oxygen in the exhaust system. An electronic circuit within the ECM controls the pump current through the oxygen pumping cell in order to maintain a constant voltage in the oxygen sensing cell. The ECM monitors the voltage variation in the sensing cell and attempts to keep the voltage constant by increasing or decreasing the amount of current flow, or oxygen ion flow, to the pumping cell. By measuring the amount of current required to maintain the voltage in the sensing cell, the ECM can determine the concentration of oxygen in the exhaust. The HO2S voltage is displayed as a lambda value. A lambda value of 1 is equal to a stoichiometric air fuel ratio of 14.7:1. Under normal operating conditions, the lambda value will remain around 1. When the fuel system is lean, the oxygen level will be high and the lambda signal will be high or more than 1. When the fuel system is rich, the oxygen level will be low, and the lambda signal will be low or less than 1. The ECM uses this information to maintain the correct air/fuel ratio. If the ECM detects that the HO2S signal voltage is low, this DTC sets.

The ECM detects that the HO2S signal voltage is out of range for more than 4 seconds.

DTCs P0130 and P0150 are Type B DTCs.

DTCs P0130 and P0150 are Type B DTCs.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

1. Engine running at normal operating temperature, verify the scan tool Loop Status Bn. 1 Sen. 1 and Loop Status Bn. 2 Sen. 1 parameters display Closed Loop.
2. If the vehicle passes the Circuit/System Verification test, then operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.

1. Ignition OFF, disconnect the harness connector at the appropriate HO2S sensor.
2. Ignition ON, test for 350-550 mV between the reference voltage circuit and the low reference circuit.

⇒	If less than the specified range, test the reference voltage circuit and the low reference circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the ECM.

⇒	If greater than the specified range, test the reference voltage circuit and the low reference circuit for a short to voltage. If the circuits test normal, replace the ECM.

3. Test for 50-90 mV between the input pump current circuit and ground.

⇒	If less than the specified range, test the input pump current circuit and the pump current circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the ECM.

⇒	If greater than the specified range, test the input pump current circuit and the pump current circuit for a short to voltage. If the circuits test normal, replace the ECM.

4. If all circuits test normal, replace the HO2S sensor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.