Schematic Reference: Audible Warnings Schematics

Did you perform the Audible Warnings Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Audible Warnings

Do any indicators illuminate when the chime sounds?

Go to Symptoms - Instrument Panel, Gages and Console

Go to Step 3

1. Turn OFF the ignition.
2. Remove the key from the ignition.
3. Turn the headlamp switch to OFF.
4. Open the driver's door.

Does the chime sound?

Go to Step 4

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Disconnect the BCM connector C1.
2. Turn ON the ignition.

Does the chime sound?

Go to Step 16

Go to Step 5

1. Reconnect the BCM connector C1.
2. With a scan tool, observe the Park Lamp Input in the BCM Lamp Status data list.

Does the Park Lamp Input parameter display Off?

Go to Step 6

Go to Step 7

1. Close the driver's door.
2. With a scan tool, observe the Driver Door Ajar Sw. parameter in the BCM data list.

Does the parameter display Off?

Go to Step 8

Go to Courtesy Lamps Always On in Lighting Systems

1. Turn OFF the ignition.
2. Disconnect the BCM connector C2.
3. Connect a test lamp between the park lamp switch on input circuit and a good ground.

Does the test lamp illuminate?

Go to Step 9

Go to Step 15

1. Turn OFF the ignition.
2. Remove the key from the ignition.
3. Disconnect the BCM connector C3.
4. Connect a test lamp between the key in ignition signal circuit and battery positive voltage.

Does the test lamp illuminate?

Go to Step 10

Go to Step 15

Test the park lamp switch on input circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 11

Test the key in ignition signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 12

Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 13

Inspect for poor connections at the harness connector of the ignition key alarm switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 14

Replace the headlamp switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Standard or Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Did you complete the replacement?

Go to Step 17

--

Replace the ignition switch. Refer to Ignition Switch Replacement - On Vehicle in Steering Wheel and Column - Standard or Ignition Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Did you complete the replacement?

Go to Step 17

--

Important: Program the replacement BCM.

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 17

--

Important: Perform the set up procedure for the replacement radio.

Replace the radio. Refer to Radio Replacement in Entertainment.

Did you complete the replacement?

Go to Step 17

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3