Removal Procedure
- Remove the front door
trim panel upper extension. Refer to
Upper Extension Trim Panel Replacement
.
- Remove the front door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Remove the front door water deflector as required.
- Mark and remove the wires from the power door lock switch, if
equipped.
- Mark and remove the wires from the door lock (5).
- Disconnect the electrical connector for the power window regulator,
if equipped.
- Disconnect the electrical connector for the power rear view mirror,
if equipped.
- Disconnect the electrical connector for the radio speaker.
- Using a flat-bladed tool, remove the door rubber conduit from
where it attaches at the windshield pillar.
- Using a flat-bladed tool, remove the door rubber conduit from
where it attaches to the door.
- Disconnect the harness electrical connectors (2) from the front
door.
- Remove the front door wiring harness out from the door.
- Remove the conduit from the harness.
Installation Procedure
- Pull the wiring harness
to the front door through the rubber conduit.
- Install the rubber conduit to the front door.
- Install the rubber conduit to the windshield pillar.
- Connect the front door wiring harness connectors (2) to
the door.
- Install the wires to the power door lock switch, if equipped.
- Install the wires to the door lock.
- Connect the electrical connector for the power window regulator,
if equipped.
- Connect the electrical connector to the power rear view mirror,
if equipped.
- Connect the electrical connector to the radio speaker.
- Install the front door water deflector as required.
- Install the front door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Install the front door trim panel upper extension. Refer to
Upper Extension Trim Panel Replacement
.