Removal Procedure
- Remove the front bucket seat. Refer to Seat Replacement .
- Remove the front bucket seat cushion outer trim panel screws.
- Remove the front bucket seat cushion outer trim panel from the recliner mechanism.
- Remove the lumbar knob and the accouter from the driver's seat, if equipped. Refer to Front Seat Lumbar Support Replacement .
- Disconnect the cable from the lumber accouter, if equipped.
- Remove the front bucket seat recliner bolts (6).
- Remove the front bucket seat back pivot bolt (3).
- Remove the front bucket seat back (1) from the seat cushion (5).
Installation Procedure
- Install the front bucket seat back (1) to the seat cushion (5).
- Install the front seat back pivot bolt (3).
- Install the front seat recliner bolts (6).
- Install the lumbar knob and the accouter to the driver's seat, if equipped. Refer to Front Seat Lumbar Support Replacement .
- Install the front bucket seat cushion outer trim panel to the recliner mechanism.
- Install the front bucket seat cushion outer trim panel screws.
- Install the front bucket seat. Refer to Seat Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the pivot bolt to 23 N·m (17 lb ft).
Tighten
Tighten the recliner bolts to 24 N·m (18 lb ft).
Tighten
Tighten the screws to 3 N·m (27 lb in).
