Removal Procedure
- Remove the front bucket seat. Refer to Seat Replacement .
- Remove the lumbar knob and the accouter from the driver's seat, if equipped. Refer to Front Seat Lumbar Support Replacement .
- Remove the front bucket seat cushion trim panel screws.
- Remove the front bucket seat cushion trim panel from the recliner mechanism.
- Remove the front bucket seat recliner bolts (6).
- Remove the front bucket seat back pivot bolt (3).
- Remove the front bucket seat back (1) from the front seat cushion (5).
If lumbar equipped, route the cable through the seat cushion (5).
Installation Procedure
- Install the front seat back (1) to the front seat cushion (5).
- Install the front bucket seat back pivot bolt (3).
- Install the front bucket seat recliner bolts.
- Install the front bucket seat cushion trim panel to the recliner mechanism.
- Install the front bucket seat cushion trim panel screws.
- Install the lumbar knob and the accouter to the driver's seat, if equipped. Refer to Front Seat Lumbar Support Replacement .
- Install the front seat. Refer to Seat Replacement .
If lumbar equipped, route the cable through the seat cushion (5).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the pivot bolt to 23 N·m (17 lb ft).
Tighten
Tighten the recliner bolts to 24 N·m (18 lb ft).
Tighten
Tighten the screws to 3 N·m (27 lb in).
