Tools Required

1. Remove the drive belt from the drive pulleys. Refer to Drive Belt Replacement .
2. Remove the vacuum line from the vacuum pump.



3. Remove the bolt retaining the ground strap and the battery negative cable from the vacuum pump.



4. Remove the vacuum pump mounting bolts.
5. Remove the vacuum pump from the generator bracket.



6. Remove the vacuum pump pulley:

6.1.	Place the vacuum pump in a vise.

6.2.	Attach the J 25034-C to the pulley.

6.3.	Remove the pulley from the vacuum pump using the J 25034-C .




7. Install the vacuum pump pulley on the vacuum pump.

7.1.	Attach the J 25033-C to the vacuum pump pulley.

7.2.	Install the vacuum pump pulley to the vacuum pump.

7.3.	Remove the J 25033-C .

8. Remove the vacuum from the vise.

1. Install the vacuum pump.



2. Install the bolt retaining the ground strap and the battery negative cable to the vacuum pump.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the mounting bolts.

Tighten
Tighten the bolts to 25 N·m (18 lb ft).




4. Install the vacuum line to the vacuum pump.
5. Install the drive belt on the drive pulleys. Refer to Drive Belt Replacement .