Tools Required

1. Remove the manual transmission. Refer to Transmission Replacement in Manual Transmission - NV 4500.
2. Remove the clutch pressure plate bolts.

Important: Dowel pins are used to align the flywheel and pressure plate. When removing the pressure plate check to see if the dowel pins are rusted into the pressure plate, if so remove, clean, and reinstall the dowel pins into the correct locations on the flywheel.

3. Remove the clutch pressure plate and driven plate from the dowel pins.

1. Install the clutch pressure plate and driven plate to the dowel pins.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install J 44747 to align the clutch.
3. Install the clutch pressure plate bolts.

Tighten
Tighten the clutch pressure plate bolts to 70 N·m (52 lb ft).

4. Remove the J 5824-A .
5. Install the manual transmission. Refer to Transmission Replacement in Manual Transmission - NV 4500.