GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Chevy C Silverado - 2WD 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Air Conditioning Condenser Replacement

Removal Procedure
  1. Drain the engine coolant. Refer to Cooling System Draining and Filling in Engine Cooling.
  2. Disconnect the electrical connector from the air inlet duct.
  3. Remove the PCV hose from the air cleaner.
  4. Remove the air inlet assembly.
  5. Remove the radiator. Refer to Refrigerant Recovery and Recharging in Engine Cooling.
  6. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging in Engine Cooling.
  7. Remove the compressor discharge hose assembly from the condenser. Refer to Compressor Hose Assembly Replacement .
  8. Remove the discharge hose. Refer to Discharge Hose Replacement .
  9. Remove the evaporator tube from the condenser.
  10. Remove the insulator retainer bolts and the upper insulator retainers.

    11. Object Number: 281181 Size: SH
  11. Remove the condenser.

Installation Procedure

    Object Number: 281181 Size: SH
  1. Install the condenser.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the upper insulator retainers and the insulator retainer bolts.

    3. Tighten
    Tighten the bolts to 2.4 N·m (21 lb in).

  3. Install the evaporator tube to the condenser.
  4. Install the discharge hose. Refer to Discharge Hose Replacement .
  5. Install the compressor discharge hose assembly to the condenser. Refer to Compressor Hose Assembly Replacement .
  6. Install the radiator. Refer to Radiator Replacement in Engine Cooling.
  7. Install the air inlet assembly.
  8. Connect the PCV hose to the air cleaner.
  9. Connect the electrical connector to the air inlet duct.
  10. Fill the engine coolant. Refer to Cooling System Draining and Filling in Engine Cooling.
  11. Add refrigerant to the system. Refer to Refrigerant Recovery and Recharging .
  12. Leak test the fitting(s) of the repaired or reinstalled component using the J 39400 .