Preliminary Procedures

1. Remove the tail lamps and side marker lamps. Refer to Tail Lamp Replacement .
2. Remove the license lamp. Refer to Rear License Lamp Replacement .
3. Remove the rear wheel liners. Refer to Rear Wheelhouse Panel Liner Replacement .

1

Rear Bumper Fascia - Upper Retainers (Qty: 4)

2

Rear Bumper Fascia Tail Lamp Pocket Screws (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

3

Rear Bumper Fascia (Inside wheel well) Bolts (Qty: 2)

Tighten
2.5 N·m (22 lb in)

4

Rear Bumper Fascia Retainers (Qty: 4)

5

Rear Bumper Fascia

Tip
Pull the sides of the rear fascia at the quarter panel to release the fascia from the brackets.

Preliminary Procedures

1. Remove the tail lamps. Refer to Tail Lamp Replacement .
2. Remove the license lamp. Refer to Rear License Lamp Replacement .
3. Remove the rear wheel liners. Refer to Rear Wheelhouse Panel Liner Replacement .

1

Rear Bumper Fascia - Upper Screws (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Rear Bumper Fascia - Upper Retainers (Qty: 6)

Tighten
2 N·m (18 lb in)

3

Rear Bumper Fascia Bolts (Qty: 2)

Tip
Access the bolt from inside the wheel well.

Tighten
2.5 N·m (22 lb in)

4

Rear Bumper Fascia - Lower Retainers (Qty: 4)

5

Rear Bumper Fascia

Tip

1. Pull the sides of the rear fascia at the quarter panel to release the fascia from the brackets.
2. Disconnect the license lamp connector.