Tools Required

1. Remove the lower and upper shrouds. Refer to Steering Column Trim Cover Replacement - Off Vehicle .
2. Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement - Off Vehicle .
3. Remove the shaft lock shield assembly.
4. Remove the turn signal cancel cam assembly.



5. Remove the upper tilt head components. Refer to Upper Tilt Head Components .



6. Remove the turn signal and multifunction switch assembly.
7. Remove the tilt spring. Refer to Tilt Spring - Off Vehicle .



8. Remove the steering wheel position sensor. Refer to Steering Wheel Position Sensor Replacement



9. Remove the adapter and bearing assembly from the jacket assembly.



10. Use tool J 21854-01 to remove the two pivot pins.



11. Perform the following steps to remove the steering column tilt head assembly with the steering shaft assembly:

11.1.

Mark the race and upper shaft assembly and mark the lower steering shaft to ensure proper assembly. Failure to assemble properly will cause steering wheel to be turned 180 degrees.

11.2.

Install and pull the tilt arm to disengage the steering wheel lock shoes from the dowel pins in the steering column support assembly.




12. Remove the four torx head screws.
13. Remove the column support assembly.

1. Install the column support assembly.
2. Install the four torx head screws.

Tighten
Tighten the screws to 9 N·m (80 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the steering shaft and tilt head assembly.



4. Install the two piviot pins.



5. Perform the following steps to install the adapter and bearing assembly to the steering column jacket assembly:

5.1.	Position the tab on the adapter and bearing assembly with the slot in the steering column jacket assembly.

5.2.	Push together the tab into the slot in the steering column jacket assembly.




6. Install the steering wheel position sensor.



7. Install the tilt head spring. Refer to Tilt Spring - Off Vehicle

.

8. Install the upper tilt head components. Refer to Upper Tilt Head Components .



9. Install the turn signal and multifunction switch assembly to the column.

Tighten
Tighten the screws to 6 N·m (53 lb in).




10. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement - Off Vehicle .
11. Install the lower and upper shrouds. Refer to Steering Column Trim Cover Replacement - Off Vehicle .