Park/Turn Signal/Side Marker Lamp Replacement Assembly Replacement

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
3. Release the brake caliper cooling duct from the front fascia, then repositon the duct.



4. Unhook the front turn signal lamp bracket retaining spring from the lamp bracket.
5. Unhook the lamp bracket retaining spring from the front fascia.
6. Remove the front turn signal lamp bracket retaining screws.



7. Disconnect the sockets from the lamp.



8. Remove the lamp (with the bracket) from the vehicle.
9. Remove the lamp to bracket retaining screws.
10. Remove the lamp from the bracket.

1. Install the front park/turn signal and sidemarker lamp into position on the front turn signal lamp bracket.
2. Install the the front park/turn signal and sidemarker lamp to bracket retaining screws.

Tighten
Tighten the front park/turn signal and sidemarker lamp to bracket retaining screws to 1.5 N·m (13 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the sockets to the lamp.



4. Install the lamp (with the bracket) to the front fascia.
5. Align the lamp to the opening in the front fascia and hold firmly in place against the fascia, then install the front turn signal lamp bracket retaining screws.

Tighten
Tighten the front turn signal lamp bracket retaining screws to 2.5 N·m (22 lb in).

6. Hook the lamp bracket retaining spring to the front fascia.
7. Hook the front turn signal lamp bracket retaining spring to the lamp bracket.



8. Position the brake caliper cooling duct to the front fascia and push to secure.
9. Install the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.

Park/Turn Signal/Side Marker Lamp Replacement Bulb Replacement

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
3. Release the brake caliper cooling duct from the front fascia, then repositon the duct.



4. Remove the appropriate socket from the lamp assembly.
5. Remove the bulb from the socket.

1. Install the bulb to the socket.
2. Install the socket to the lamp assembly.



3. Position the brake caliper cooling duct to the front fascia and push to secure.
4. Install the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
5. Lower the vehicle.