Front Fog Lamp Replacement Assembly

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
3. Release the brake caliper cooling duct from the front fascia, then reposition the duct.



4. Disconnect the front fog lamp electrical connector.



5. Remove the front fog lamp mounting bolt.
6. Remove the lamp from the vehicle.

1. Position the front fog lamp to the front impact bar.

Insert the fog lamp bracket alignment tab into the hole on the front impact bar.

2. Install the front fog lamp mounting bolt.

Tighten
Tighten the front fog lamp mounting bolt to 1.9 N·m (17 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Connect the front fog lamp electrical connector.



4. Position the brake caliper cooling duct to the front fascia, then push to secure.
5. Install the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
6. Lower the vehicle.
7. Verify that the front fog lamps are aimed properly. Refer to Fog Lamp Aiming .

Front Fog Lamp Replacement Bulb

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
3. Release the brake caliper cooling duct from the front fascia, then reposition the duct.



4. Disconnect the front fog lamp electrical connector.



5. Remove the fog lamp bulb from the fog lamp.

1. Install the fog lamp bulb to the fog lamp assembly.



2. Connect the front fog lamp electrical connector.



3. Position the brake caliper cooling duct to the front fascia, then push to secure.
4. Install the front fascia lower closeout panel. Refer to Front Fascia Lower Close Out Panel in Bumpers and Fascias.
5. Lower the vehicle.
6. Verify that the front fog lamps are aimed properly. Refer to Fog Lamp Aiming .