Notice: Whenever the Instrument Panel Cluster (IPC) is removed from the vehicle, DO NOT set the IPC on its face for more than 15 minutes or damage to the fluid filled air core gages may result.

1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to Instrument Cluster Replacement .
2. Disconnect the instrument panel (I/P) dimmer switch electrical connector.



3. Disconnect the driver information center (DIC) switch electrical connector.



4. Remove the I/P cluster bezel retaining screws.
5. Remove the bezel from the IPC.



6. Remove the DIC switch retaining screws.
7. Remove the DIC switch.

1. Install the DIC switch to the I/P cluster bezel.
2. Install the DIC switch retaining screws.

Tighten
Tighten the DIC switch retaining screws to 1.5 N·m (13 lb in).

Refer to

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

in General Information.



3. Install the bezel to the IPC.

Align the bezel onto the guide pins.

4. Install the I/P cluster bezel retaining screws.

Tighten
Tighten the I/P cluster bezel retaining screws to 1.5 N·m (13 lb in).




5. Connect the I/P dimmer switch electrical connector.



6. Connect the DIC switch electrical connector.
7. Install the IPC to the vehicle. Refer to Instrument Cluster Replacement .