Removal Procedure
- Remove the accessory trim plate. Refer to Console Replacement in Instrument Panel, Gages, and Console.
- Remove the passenger seat. Refer to Driver and Passenger Seat Replacement in Seats.
- Lift and disengage the retainer clips on the park brake lever boot.
- Disconnect the parking brake electrical connector.
- Disable the parking brake automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
- Remove the parking brake lever assembly mounting bolts.
- Reposition the park brake lever.
- Disconnect the front parking brake cable from the drive sector and park brake lever assembly.
Installation Procedure
- Connect the front parking brake cable to the drive sector and park brake lever assembly.
- Install the parking brake lever assembly mounting bolts.
- Connect the parking brake electrical connector.
- Enable the parking brake automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
- Install the parking brake lever boot nuts.
- Install the passenger seat. Refer to Driver and Passenger Seat Replacement in Seats.
- Install the accessory trim plate. Refer to Console Replacement in Instrument Panel, Gages, and Console.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the parking brake lever assembly mounting bolts to 28 N·m (21 lb ft).
Tighten
Tighten the parking brake lever boot nuts to 10 N·m (89 lb in).
