For 1990-2009 cars only
Removal Procedure
- Remove the roof front stowage bracket by twisting the egg shaped bracket 90 degrees clockwise.
- Remove the bezel from the roof front stowage bracket mounting plate by prying up the bezel.
- Remove the floor carpet to access the mounting plate bolts. Refer to Rear Compartment Floor Panel Carpet Replacement .
- Remove the bolts attaching the roof front stowage bracket mounting plate.
- Remove the roof front stowage bracket mounting plate.
Installation Procedure
- Position the mounting plate to the rear compartment floor.
- Install the bolts attaching the mounting plate.
- Install the floor carpeting. Refer to Rear Compartment Floor Panel Carpet Replacement .
- Snap the bezel onto the ribs on the mounting plate. Press firmly around the entire periphery of the bezel.
- Install the stowage bracket. Rotate the egg shaped bracket 90 degrees counterclockwise to secure the bracket.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
| 2.1. | Install the rear inboard bolt first. |
| 2.2. | Install the rear outboard bolt second. |
| 2.3. | Install the forward bolt third. |
Tighten
Tighten the roof stowage bracket mounting plate bolts to 8 N·m
(71 lb in).
