Shift Linkage Adjustment for Chevrolet Corvette 2008

1. Apply the parking brake.
2. Remove the shift control closeout boot. Refer to Shift Control Shift Closeout Boot Replacement .
3. Place the shifter into NEUTRAL.
4. Press down to engage the shift control neutral lock pin.



5. Loosen the transmission shift rod clamp bolt.
6. Loosen the shift control mounting bolts.
7. Check that the shift control locator (on the underside of the shift control) is installed into the shifter bracket on the side of the driveline support assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

8. Tighten the shift control mounting bolts.

Tighten
Tighten the shift control mounting bolts to 30 N·m (22 lb ft).

9. Tighten the transmission shift rod clamp bolt.

Tighten
Tighten the transmission shift rod clamp bolt to 30 N·m (22 lb ft).




10. Lift to release the shift control neutral lock pin.
11. Install the shift control closeout boot. Refer to Shift Control Shift Closeout Boot Replacement .
12. Release the parking brake.