Driver or Passenger Seat Back Cushion Heater Replacement Fold Flat

1. Remove the front seat. Refer to Front Seat Replacement - Bucket .



2. Remove the screws from the outboard recliner trim panel. Remove the trim panel.



3. Remove the screws from the inboard recliner trim panel. Remove the trim panel.
4. Remove the head restraint. Refer to Front Seat Head Restraint Replacement .
5. Disconnect the electrical connector from the seat heater element.



6. Remove the bolts from the seat back frame. Remove the seat back assembly.



7. Remove the screws from the back panel. Remove the back panel.



8. Disconnect the lower J-hook retainer from the seat back trim cover.
9. Lift the trim cover, carefully disengaging the hook and loop retainers until the heater element is exposed.



10. Gently pull to remove the element from the seat back pad. Be careful not to damage the pad.

1. Peel off the self-stick paper backing from the heater element.
2. Position the element on the pad and press firmly to install the element.
3. Lower the seat back trim cover. Press on the hook and loop retainers to engage the retainers.



4. Connect the lower J-hook retainer on the seat back trim cover.

Notice: Refer to Title not found in the Preface section.




5. Position the seat back panel. Secure the panel with the screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).




6. Position the seat back assembly between the fold-flat recliners. Secure with the seat back bolts.

Tighten
Tighten the bolts to 70 N·m (52 lb ft).

7. Connect the electrical connectors to the seat heater element.
8. Install the head restraint. Refer to Front Seat Head Restraint Replacement .



9. Position the inboard recliner trim panel. Secure with the panel screws.

Tighten
Tighten the screws to 2.5 N·m (22 lb in).




10. Position the outboard recliner trim panel. Secure with the panel screws.

Tighten
Tighten the screws to 2.5 N·m (22 lb in).

11. Install the front seat. Refer to Front Seat Replacement - Bucket .

Driver or Passenger Seat Back Cushion Heater Replacement Non-Fold Flat

1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
2. Remove the outer trim panel from the seat cushion. Refer to Front Seat Cushion Outer Trim Panel Replacement .
3. Disconnect the electrical connector from the seat heat module.



4. Disconnect the lower J-hook retainer from the seat back trim cover.
5. Carefully lift the trim cover, disengaging the hook and loop retainers until the heater element is exposed.



6. Gently pull on the heater element in order to remove the element from the seat foam. Be careful not to damage the foam pad.

1. Peel off the self-stick tape from the back side of the heater element.
2. Position the heater element over the seat foam pad. Press firmly to engage the adhesive.
3. Lower the seat back trim cover, pressing on the hook and loop retainers in order to engage the retainers.



4. Connect the lower J-hook retainer to the seat back trim.
5. Connect the electrical connector to the heater element module.
6. Install the outer trim panel to the seat cushion. Refer to Front Seat Cushion Outer Trim Panel Replacement .
7. Install the front seat. Refer to Front Seat Replacement - Bucket .