Air Conditioning Compressor Replacement LNJ

Special Tools

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
3. Remove the accessory drive belt from the compressor pulley. Refer to Drive Belt Replacement.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



5. Remove the compressor hose nut from the compressor.
6. Remove the compressor hose from the compressor.
7. Disconnect the electrical connector from the compressor.
8. Remove and discard the seal washers from the compressor. Refer to Sealing Washer Replacement.
9. Install a shipping cap on the compressor hose to prevent moisture/contamination.



10. Install shipping cap to the compressor (2) prior to removal to prevent spillage of oil and contamination.
11. Remove the compressor bolts (3, 4, 5) from the compressor.
12. Remove the spacer bracket (1) from the compressor.
13. Remove the compressor (2) from the vehicle.
14. If replacing the compressor (2), balance the oil. Refer to Air Conditioning Compressor Oil Balancing.

1. Add the proper amount of polyalkylene glycol (PAG) oil to the compressor (2). Refer to Refrigerant System Capacities.
2. Install caps on compressor (2) to prevent spillage during installation.
3. Install the compressor (2) to the vehicle.
4. Install the spacer bracket (1) between the engine and the compressor (2).

Caution: Refer to Fastener Caution in the Preface section.

5. Install the compressor bolts to the compressor (2). Tighten the bolts in sequence.

•	Tighten the bolt (5) to 50 N·m (37 lb ft).

•	Tighten the bolt (3) to 50 N·m (37 lb ft).

•	Tighten the bolt (4) to 50 N·m (37 lb ft).

6. Remove the shipping cap from the compressor (2) and the compressor hose.
7. Connect the electrical connector to the compressor (2).



8. Install new seal washers to the compressor. Refer to Sealing Washer Replacement.
9. Install compressor hose to the compressor.

Caution: Refer to Compressor Hose Clearance to the Exhaust Gas Circulation Pipe Caution in the Preface section.

10. Position the compressor hose to the compressor and tighten the nut to 20 N·m (15 lb ft).
11. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.
12. Install the accessory drive belt to the compressor pulley. Refer to Drive Belt Replacement.
13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
14. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
15. Test the affected A/C joints for leaks using J 39400-A .

Air Conditioning Compressor Replacement LY7