Headlamp Replacement Torrent

Headlamp Replacement Equinox

1. Open the hood.



2. Remove the fascia to tie bar push-in retainers (1).



3. Gently pull the top of the fascia assembly several inches away from the vehicle to release the radiator grille strap from the headlamp.
4. Place a piece of tape over the radiator grille strap to headlamp retaining clip to prevent scratching of the headlamp lens.



5. Remove the headlamp bolts (1, 2).



6. Pull gently on the bottom outboard corner of the headlamp to disengage the lower rear headlamp retainer.
7. Remove the headlamp from the vehicle.

1. Position the headlamp into the headlamp opening.



2. Push the headlamp back into position until the lower rear retainer is fully engaged.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the headlamp bolts (1, 2) and tighten to 2.5 N·m (22 lb in).
4. Remove the tape from the radiator grille strap retainer.



5. Position the fascia assembly and engage the radiator grille strap retainer into the headlamp.



6. Install the fascia to tie bar push-in retainers (1).
7. Close the hood.
8. Check and adjust the front headlamp aim after the headlamp has been reinstalled. Refer to Headlamp Aiming.