GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Express 🢒 Brakes 🢒 Park Brake 🢒 Parking Brake Lever Pedal Assembly Replacement

Removal Procedure
  1. Complete the pedal pin up procedure. Refer to Parking Brake Cable Adjuster Disabling.

    2. Object Number: 1207190 Size: SH
  2. Remove the release handle. Refer to Parking Brake Release Handle Assembly Replacement.
  3. Remove the left side kick panel. Refer to Body Hinge Pillar Trim Panel Replacement.
  4. Remove the left floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side.
  5. Remove the pedal retaining nuts.
  6. Remove the pedal from the vehicle.
  7. Remove the front brake cable from the pedal.

Installation Procedure
  1. Connect the front brake cable to the pedal.

    2. Object Number: 1207190 Size: SH
  2. Install the pedal to the vehicle.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the pedal retaining nuts and tighten to 25 N·m (18 lb ft).
  4. Install the left floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side.
  5. Install the left side kick panel. Refer to Body Hinge Pillar Trim Panel Replacement.
  6. Install the release handle. Refer to Parking Brake Release Handle Assembly Replacement.
  7. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling.
  8. Verify that the vehicle will hold position with the brake pedal depressed.
  9. If additional adjustments need to be made, refer to Park Brake Adjustment.