GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Express - AWD 🢒 General Information 🢒 General Information 🢒 Rear Bumper Replacement

Removal Procedure
  1. Mark the location of the braces and the fasteners.

    2. Object Number: 776150 Size: SH
  2. Remove the nuts (1) that retain the rear bumper outer and inner braces to the frame.
  3. Remove the bumper (3) from the vehicle.
  4. Remove the rear bumper braces from the bumper. Refer to Rear Bumper Bracket Replacement .
  5. Remove the rear bumper step pad from the bumper. Refer to Rear Bumper Step Pad Replacement .
  6. Remove the rear bumper step pad extensions from the bumper, if equipped. Refer to Rear Bumper Step Pad Extension Replacement .

Installation Procedure
  1. Install the rear bumper step pad to the bumper. Refer to Rear Bumper Step Pad Replacement .
  2. Install the rear bumper step pad extensions to the bumper. Refer to Rear Bumper Step Pad Extension Replacement .
  3. Install the rear bumper braces to the bumper. Refer to Rear Bumper Bracket Replacement .

    4. Object Number: 776150 Size: SH
  4. Install the bumper (3) to the vehicle.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the inner and outer bumper impact bar brace retaining nuts (1) to the frame.

    6. Tighten
    Tighten the inner and outer bumper impact bar brace retaining nuts to 50 N·m (37 lb ft).