GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Impala 🢒 Restraints 🢒 SIR 🢒 Front Seat Replacement - Bucket

Removal Procedure
  1. Disable the SIR system, if the seat is equipped with a driver side air bag. Refer to Disabling the SIR System in SIR.
  2. Position the seat forward and in the full up position.
  3. Remove the track covers from the seat adjuster. Refer to Front Seat Adjuster Track Finish Cover Replacement .

    4. Object Number: 370568 Size: SH
  4. Remove the seat belt nut from the front seat track.
  5. Remove the head restraint. Refer to Front Seat Head Restraint Replacement .

    6. Object Number: 305124 Size: SH
  6. Remove the bolts which secure the seat adjuster to the floor pan at the rear of the seat.
  7. Disengage the seat hook attachments from the floor pan.
  8. Tip the seat back and disconnect the following connectors, if equipped.
    9. • The power seat electrical connector
    • The electrical seat heater connector
    • The driver side air bag electrical connector
  9. Remove the front bucket seat.

Installation Procedure

    Object Number: 305124 Size: SH
  1. Position the front bucket seat into place.
  2. Tip the seat back and connect the following connectors, if equipped.
    3. • The power seat electrical connector
    • The electrical seat heater connector
    • The driver side air bag electrical connector
  3. Engage the seat hook attachments to the floor pan.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the bolts which secure the front bucket seat adjuster to the floor pan.

    5. Tighten
    Tighten the bolts to 42 N·m (31 lb ft).

  5. Install the adjuster track covers. Refer to Front Seat Adjuster Track Finish Cover Replacement .

    6. Object Number: 370568 Size: SH
  6. Install the seat belt nut to the front seat stud.

    7. Tighten
    Tighten the nut to 42 N·m (31 lb ft).

  7. Install the head restraint. Refer to Front Seat Head Restraint Replacement .
  8. Enable the SIR system. Refer to Enabling the SIR System in SIR.
  9. Inspect the seat for proper operation and adjustment.
  10. Position the seat to the original position.