Sunroof Module Assembly Replacement MD4

Important: A new sunroof module assembly will not have the sunroof window or sunshade as components of the new service part.

1. The old sunroof window and sunshade will need to be installed to the new sunroof module assembly.
2. Remove the sunroof window. Refer to Sunroof Window Replacement .



3. Remove the sunshade panel. Refer to Sunroof Sunshade Replacement .
4. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
5. Disconnect the electrical connector from the sunroof module.



6. Disconnect the front and rear drain hoses from the sunroof module.



7. Have an assistant support the sunroof module.
8. Remove the bolts from the sunroof module.
9. Remove the sunroof module from the vehicle with an assistant.

1. Position the sunroof module to the vehicle roof with an assistant.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the sunroof module bolts.

Tighten
Tighten the sunroof module bolts to 10 N·m (89 lb in).




3. Connect the front and rear drain hoses to the sunroof module.



4. Connect the electrical connector to the sunroof motor/actuator.
5. Install the sunshade panel. Refer to Sunroof Sunshade Replacement .
6. Install the sunroof window. Refer to Sunroof Window Replacement .
7. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
8. Inspect for proper operation of the sunroof. Refer to Sunroof Description and Operation .
9. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.