The Diagnostic System Check - Automatic Transmission is an organized approach to identifying a condition created by an electronic transmission control system. The Diagnostic System Check - Automatic Transmission is intended for use in diagnosing a vehicle with separate engine and transmission control modules, ECM and TCM.
Diagnostic Aids
Inspect all of the related wiring and connections including the connections at the TCM, as these may cause an intermittent concern. Inspect the terminals for any damage or any corrosion. Inspect the connector for any pushed-out terminals.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Do not perform the Diagnostic System Check - Automatic Transmission unless one of the concerns listed is present. Failure to follow this procedure could lead to misdiagnosis of the system.
Step | Action | Yes | No |
|---|---|---|---|
1 | Note the A/T warning lamp as the ignition switch is turned to ON. Does the A/T warning lamp illuminate steady for 3 seconds and then go OFF? | System OK | Go to Step 2 |
2 | Does the A/T warning lamp flash continuously? | Go to Automatic Transmission Warning Lamp Flashes Continuously | Go to Step 3 |
3 | Display flash code DTCs. Refer to Reading Diagnostic Trouble Codes . Are there any DTCs displayed? | Go to Step 4 | |
4 |
Are all DTCs diagnosed and malfunctions repaired? | -- |
