GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 9886-01 Door Handle Clip Remover

Removal Procedure


    Object Number: 5087  Size: SH
  1. Use J 9886-01 in order to remove the window regulator handle, if equipped.
  2. Remove the door trim plate. Refer to Rear Door Trim Plate Replacement .
  3. Remove the screws from the pull handle. Refer to Armrest Replacement .

  4. Object Number: 823469  Size: SH
  5. Lift up on the front door trim panel in order to release the retaining tabs on the front door trim panel.
  6. Remove the door trim panel from the vehicle.

Installation Procedure


    Object Number: 823469  Size: SH
  1. Install the door trim panel to the vehicle.
  2. Align the retaining tabs on the front door trim panel with the holes in the door.
  3. Push on the retaining tabs in order to lock the retaining tabs into place.

  4. Object Number: 333938  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the screws to the pull handle.
  6. Tighten
    Tighten the pull handleretaining screws to 1.9 N·m (17 lb in).

  7. Install the door trim plate. Refer to Rear Door Trim Plate Replacement .
  8. Install the window regulator handle (1), if equipped.