Removal Procedure
- Remove the front seat. Refer to
Seat Replacement
.
- Remove the six-way power
seat adjuster (2). Refer to
Front Seat Adjuster Replacement
.
- Disassemble the following:
| 3.1. | Remove the feed wires from the following motors: |
| • | Front vertical gearnut motor (6). |
| • | Rear vertical gearnut motor (7). |
| • | Horizontal adjuster motor (11). |
| 3.2. | Remove the nut securing the front of the motor support bracket
(4) to the inboard adjuster and partially withdraw it from the adjuster (1)
and gear-nut drives (3, 13). |
| 3.3. | Remove the following drive cables from the motors and complete
disassembly of support bracket (4) with motors attached: |
| • | Front vertical drive cable (8). |
| • | Rear vertical drive cable. |
| • | Horizontal drive cable (10). |
- Grind off peened over end(s) of grommet securing motor to support
and separate motor(s) as required from support.
- Drill out the top end of grommet using an 8 mm (3/16-inch)
drill bit.
Installation Procedure
- Install the grommet to the motor support bracket and secure motor
to grommet using a 3/16-inch rivet.
- Install the drive cables to the motors.
- Install the motor to inboard adjuster and secure with nut.
- Install the motor feed wires to the motors.
- Install the six-way power
seat adjuster (2). Refer to
Front Seat Adjuster Replacement
.
- Install the front seat. Refer to
Seat Replacement
.
