- Visually inspect the trunk release/RFA fuse.
- Inspect the rear compartment lid release motor for a proper connection.
- Verify that the valet mode switch is in the OFF position.
The valet mode switch is located on the rear compartment lid release
motor.
- Verify that the transaxle gear selector is in one of the following
positions when operating the rear compartment lid release:
- Verify that the following grounds are clean and tight:
- If the trunk release is only inoperable from the keyless entry
transmitter, refer to
Rear Release Inoperative with Transmitter
in Keyless
Entry.
- Inspect for a broken (or partially broken) wire inside of the
insulation.
A broken wire inside of the insulation may cause a system failure, but
prove good in a continuity/voltage test.
- Inspect for the proper installation of aftermarket electronic
equipment, if necessary.
The improper installation of aftermarket electronic equipment may affect
the integrity of other systems.