Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
|
Important: A short to ground will cause an open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open. | ||||
1 |
Does the test lamp light? | -- | ||
2 | Review the option content of the vehicle. Is the vehicle equipped with keyless entry? | -- | ||
3 |
Does the voltage measure within the specified range? | B+ | ||
4 |
Does the test lamp light? | -- | ||
5 |
Does the test lamp light? | -- | ||
6 |
Does the voltage measure within the specified range? | B+ | ||
7 | Use a test lamp in order to backprobe the left IP wiring harness junction block between terminal C3 of connector C1 and ground. Does the test lamp light? | -- | ||
8 |
Does the rear compartment lid release motor operate? | -- | ||
9 | Repair the open in CKT 382, between the left IP wiring harness junction block and the remote control door lock receiver. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
10 | Repair the open in CKT 56, between the left IP wiring harness junction block and the rear compartment lid release motor. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
11 | Use the J 39200 DMM in order to measure the resistance between terminal D of transaxle range switch connector C1 and ground. Does the resistance measure within the specified range? | 0-2 ohms | ||
12 | Repair the open in CKT 1737, between the left IP wiring harness junction block and the transaxle range switch. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
13 |
Does the test lamp light? | -- | ||
14 | Replace the remote control door lock receiver. Refer to Receiver Replacement in Keyless Entry. Is the repair complete? | -- | System OK | -- |
15 |
Does the test lamp light? | -- | ||
16 |
Does the rear compartment lid release motor operate? | -- | ||
17 | Repair the open in CKT 451 between the transaxle range switch and ground splice pack G102. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
18 | Use a test lamp in order to backprobe the rear compartment lid release switch between terminal D and ground. Does the test lamp light? | -- | ||
19 |
Does the test lamp light? | -- | ||
20 | Repair the open in CKT 56 between the remote control door lock receiver and the rear comportment lid release motor. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
21 |
Is repair complete? | -- | System OK | -- |
22 |
Does the rear compartment lid release motor operate? | -- | ||
23 |
Does the test lamp light? | -- | ||
24 | Repair the open in CKT 1040, between the left IP wiring harness junction block and the rear compartment lid release switch. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
25 | Replace the rear compartment lid release motor. Refer to Lock System Replacement - Rear Compartment in Body Rear End. Is the repair complete? | -- | System OK | -- |
26 | Repair the open in CKT 750 between the rear compartment lid release motor and ground splice pack G401. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
27 | Replace the faulty relay. Is the repair complete? | -- | System OK | -- |
28 | Replace the left IP wiring harness junction block. Refer to Relay/Fuse Center Replacement in Wiring Systems. Is the repair complete? | -- | System OK | -- |
29 | Repair the open in CKT 1576 between the left IP wiring harness junction block and the rear compartment lid release switch. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
30 | Replace the rear compartment lid release switch. Refer to Fuel/Rear Compartment Release Switch Replacement in Instrument Panel, Gauges and Console. Is the repair complete? | -- | System OK | -- |
