Schematic Reference: Brake Warning System Schematics

Connector End View Reference: Hydraulic Brake Connector End Views

1

Did you perform the Hydraulic Brake Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Hydraulic Brakes

1. Install a scan tool.
2. Select the Body Control Module Special Functions menu on the scan tool.
3. Command the instrument panel warning lamps ON.

Does the brake warning indicator illuminate?

Go to Step 3

Go to Step 10

Apply the park brake.

Does the brake warning indicator illuminate?

Go to Step 4

Go to Step 5

1. Turn OFF the ignition.
2. Release the park brake.
3. Disconnect the brake fluid level switch.
4. Connect a 3-amp fused jumper wire between the brake fluid level switch connector terminals.
5. Turn ON the ignition with the engine OFF.

Does the brake warning indicator illuminate?

Go to Step 12

Go to Step 7

1. Turn OFF the ignition.
2. Release the park brake.
3. Disconnect the park brake switch.
4. Connect a 3-amp fused jumper wire between the park brake switch signal circuit and a good ground.
5. Turn ON the ignition with the engine OFF.

Does the brake warning indicator illuminate?

Go to Step 11

Go to Step 6

Test the park brake switch signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 9

Test the brake fluid level sensor signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 8

Inspect for poor connections at the following harness connectors:

Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 13

Inspect for poor connections at the following harness connectors:

Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 14

Go to Step 13

Replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement in Instrument Panel, Gages and Console.

Did you complete the replacement?

Go to Step 14

--

Replace the park brake switch. Refer to Parking Brake Lever Pedal Assembly Replacement in Park Brake.

Did you complete the replacement?

Go to Step 14

--

Replace the brake fluid level switch. Refer to Brake Fluid Level Indicator Switch Replacement .

Did you complete the replacement?

Go to Step 14

--

Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 14

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2