Preliminary Procedures

1. Remove the driver knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement.
2. Remove the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement.

1

Ignition and Start Switch Bolt/Screw (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
5 N·m (44 lb in)

2

Ignition and Start Switch

Procedure

1. Disconnect the electrical connections.
2. Disconnect the park lock cable from the ignition and start switch. Refer to Park Lock Cable Replacement.
3. Remove the theft deterrent control module. Refer to Theft Deterrent Module Replacement. Theft Deterrent module can only be removed after ignition switch is removed from the vehicle.
4. Transfer the bracket if necessary.