Wheel Speed Sensor Replacement Rear

Important: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a rear wheel speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Refer to Rear Wheel Bearing and Hub Replacement in Rear Suspension.

Wheel Speed Sensor Replacement Front

Important: The front sensor is serviceable only as an assembly. DO NOT attempt to service the sensor harness pigtail as it is part of the sensor.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the front electrical connector.
3. Remove the bolt retaining the sensor pigtail wire.
4. Remove the 2 bolts retaining sensor to the steering knuckle.
5. Remove the sensor.

Important: Make sure the sensor guide pins are properly aligned and sensor is seated.

1. Install the front wheel speed sensor.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the sensor retaining bolts.

TIGHTEN
Tighten to 70 N·m (52 lb ft).

3. Reconnect the electrical connector to front wheel speed sensor.