Steering Column Jacket - Assemble - Off Vehicle Floor Shift

Tools Required

1. To assemble the steering column housing assembly if needed:
2. Install the bearing assembly (1)
3. Install the shoe springs (5).
4. Install the steering wheel lock shoes (10) and (11).
5. Install the dowel pin (7).
6. Install the release lever spring (4).
7. Install the shoe release lever (2).
8. Install the lever pin (3) using J 22635 .
9. Install the drive shaft (8).
10. Install the switch actuator sector (13).
11. Install the rack preload spring (16).
12. Install the switch actuator rack (17) to the switch actuator sector (13).
13. Install the bearing assembly (12) using J 8092 and J 38639 .
14. Install the wire protector shield (9).



15. Stake the steering column housing assembly in 3 places.

Important: If the steering column housing assembly has been staked 3 times it must be replaced.

16. Install the steering column housing assembly:

16.1.

Install the tilt lever and use it to pull back on the steering column housing assembly to mount on the steering column housing support.

16.2.

Position the steering column housing assembly (1) onto the steering column housing support.

16.3.

Align the switch actuator rack with the pin on the end of the ignition switch actuator assembly.

16.4.

Pull back on the tilt lever (2) to position the steering column housing assembly (1).

16.5.

Push the steering column housing assembly (1) into the steering column housing support .

16.6.

Release the tilt lever (2) to lock the steering wheel lock shoes and the dowel pin.

16.7.

Remove the tilt lever (2).




17. Install 2 pivot pins (1).
18. Press the 2 pins (1) until they are firmly seated.
19. Install the tilt spring assembly. Refer to Lock Housing Assembly - Assemble - Off Vehicle .

Steering Column Jacket - Assemble - Off Vehicle Column Shift

Tools Required

1. To assemble the steering column housing assembly if needed:
2. Install the bearing assembly (1)
3. Install the shoe springs (5).
4. Install the steering wheel lock shoes (10) and (11).
5. Install the dowel pin (7).
6. Install the release lever spring (4).
7. Install the shoe release lever (2).
8. Install the lever pin (3) using J 22635 .
9. Install the drive shaft (8).
10. Install the switch actuator sector (13).
11. Install the rack preload spring (16).
12. Install the switch actuator rack (17) to the switch actuator sector (13).
13. Install the bearing assembly (12) using J 8092 and J 38639 .
14. Install the wire protector shield (9).



15. Stake the steering column housing assembly in 3 places.

Important: If the steering column housing assembly has been staked 3 times it must be replaced.

16. Install the steering column housing assembly:

16.1.

Install the tilt lever and use it to pull back on the steering column housing assembly to mount on the steering column housing support.

16.2.

Position the steering column housing assembly (1) onto the steering column housing support.

16.3.

Align the switch actuator rack with the pin on the end of the ignition switch actuator assembly.

16.4.

Pull back on the tilt lever (2) to position the steering column housing assembly (1).

16.5.

Push the steering column housing assembly (1) into the steering column housing support .

16.6.

Release the tilt lever (2) to lock the steering wheel lock shoes and the dowel pin.

16.7.

Remove the tilt lever (2).




17. Install 2 pivot pins (1).
18. Press the 2 pins (1) until they are firmly seated.
19. Install the tilt spring assembly. Refer to Tilt Spring - Assemble - Off Vehicle .