For 1990-2009 cars only
Removal Procedure
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
- Remove the anchor nuts securing the rear seat retainer at the bottom of the seat back (2).
- Remove the rear child seat, if equipped. Refer to Child Seat Replacement .
- Move the rear seat belts to the sides of the rear seat back.
- Grasp the bottom of the seat back and swing the seat back upward in order to disengage the offsets (1) on the upper frame bar from the hangers.
- Remove the seat.
Lift the seat upward.
Installation Procedure
- Move the seat belts to the sides of the seat back.
- Position the seat back in the vehicle.
- Hook the top of the upper frame bar (1) onto the seat back hangers.
- Install the lower seat back anchor nuts (2).
- Install the rear child seat, if equipped. Refer to Child Seat Replacement .
- Install the rear seat cushion. Refer to Rear Seat Cushion Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the rear seat back anchor nuts (2) to 10 N·m (89 lb in).
