Removal Procedure
- Open the rear door.
- Remove the trim panels. Refer to the following procedures in Interior
Trim:
- Remove the weatherstrip from the rear door opening by pulling
the weatherstrip off the pinchweld flange.
Installation Procedure
- Position the rear door
opening weatherstrip to the pinchweld flange.
Starting at the center of the rocker panel area and moving in a clockwise
direction, press the weatherstrip to the pinchweld flange until fully seated.
Important: The joint butt ends must have no gap and must be located in the center
of the of the rocker panel area.
- Install the joint butt ends together.
- Install the trim panels. Refer to the following procedures in
Interior Trim:
- Close the rear door.