When the PRNDL is placed in the REVERSE position, a GMLAN serial data message is sent from the transmission control module (TCM) to the body control module (BCM). The BCM then applies battery voltage from the CHMSL/BCK-UP fuse through the backup lamps voltage supply circuit to the tail lamp assemblies illuminating the backup lamps.

Schematic Reference

Exterior Lights Schematics

Connector End View Reference

Lighting Systems Connector End Views

Electrical Information Reference

Scan Tool Reference

Ignition ON, place the PRNDL in the REVERSE position. The backup lamps should illuminate.

1. Ignition OFF, disconnect the harness connector at the appropriate tail lamp assembly.
2. Test for less than 10 ohms between the ground circuit terminal B and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the appropriate supply voltage circuit terminal listed below and the ground circuit terminal B.

•	Sedan terminal D

•	Coupe terminal A

4. Ignition ON, cycle the PRNDL between the PARK and REVERSE positions. The test lamp should turn ON and OFF when changing between park and reverse.

⇒	If the test lamp is always ON, test the supply voltage circuit for a short to voltage. If the circuit tests normal, replace the body control module.

⇒	If the test lamp is always OFF, test the supply voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the body control module.

5. If all circuits test normal, test or replace the backup lamp bulb.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.