Removal Procedure
Important: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.
When servicing a vehicle with adjustable
outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.
- Remove the rear door trim panel. Refer to
Rear Side Door Trim Panel Replacement .
- Remove the rear door water deflector. Refer to
Rear Side Door Water Deflector Replacement .
- Raise the window to the full up position.
Notice: To avoid paint damage, protect the area surrounding the part which you
are removing or installing.
- Apply masking tape around the outside handle.
- Open the outside handle rod to lock clip located on the door lock.
- Remove the rear door lock . Refer to
Rear Door Lock Replacement .
- Remove the outside door handle bolt access tape.
- Remove the bolts (3) from the rear door handle.
- Remove the outside handle bolt (2) through the latch hole.
- Remove the outside handle (1) and the rod (2) from the door.
Installation Procedure
- Install the outside door handle (1) and the rod (2) to the door.
Notice: Refer to Fastener Notice in the Preface section.
- Install the outside handle bolt (2) through the latch hole.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Install the bolts (3) to the rear door handle.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Install the rear door lock. Refer to
Rear Door Lock Replacement .
- Install the outside door handle bolt access tape.
- Install the outside handle rod into the clip.
- Close the clip cover over the outside door handle rod.
- Inspect the outside door handle for proper operation.
- Remove the masking tape.
- Install the rear door water deflector. Refer to
Rear Side Door Water Deflector Replacement .
- Install the rear door trim panel. Refer to
Rear Side Door Trim Panel Replacement .