Circuit Description
When the ignition switch is turned to ON, the sensing and diagnostic module(SDM) will perform turn-on test to diagnose critical malfunctions within SDM itself.
Upon passing these test ignition and deployment loop voltages are measured to ensure that they are within their normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deploy loops.
Conditions for Setting the DTC
| • | The side air bag sensor wiring of the passenger high is shorted to battery wiring. |
| • | The side air bag sensor wiring of the passenger low is shorted to battery wiring. |
Step | Action | Values | Yes | No |
|---|---|---|---|---|
|
Caution: Refer to Sensing and Diagnostic Module Handling Caution in the Preface section. Caution: Refer to SRS Sensing and Diagnostic Module Handling Caution in the Preface section. | ||||
1 |
Has the SDM discharged? | -- | Go to Step 2 | -- |
2 | Visually inspect for any damage on the passenger side air bag sensor wiring and the connector. Are the passenger side air bag sensor wiring and connector OK? | -- | Go to Step 4 | Go to Step 3 |
3 | Connect the connector or repair the damage. Did you complete the action? | -- | -- | |
4 | Measure the resistance between the high, low wiring of the passenger side air bag sensor and the battery. Is the resistance equal to the specified value? | 10 K ohms | Go to Step 5 | Go to Step 7 |
5 |
Is the DTC removed? | -- | System OK | Go to Step 6 |
6 | Replace the passenger side air bag sensor. Refer to Inflatable Restraint Side Impact Sensor Replacement . Is the replacement complete? | -- | -- | |
7 | Replace the air bag wiring. Is the replacement complete? | -- | -- | |
