Did you perform the Heater Blower Controls System Check?

Go to Step 2

Go to Heater Blower Controls System Check

Test for an open in the BLK/WHT wire between the blower motor and the blower motor resistor.

Is an open present?

Go to Step 6

Go to Step 3

1. Turn the ignition switch to OFF.
2. Disconnect the blower speed selector switch.
3. Move the blower switch to the MEDIUM 1 position.
4. Test for an open between the blower speed selector switch terminals 3 and 4.
5. Move the blower switch to the MEDIUM 2 position.
6. Test for an open between the blower speed selector switch terminals 3 and 8.

Is an open present?

Go to Step 4

Go to Step 5

Replace the blower speed selector switch. Refer to Blower Switch Replacement .

Is the repair complete?

Go to Heater Blower Controls System Check

--

Replace the blower motor resistor. Refer to Blower Motor Resistor Replacement .

Is the repair complete?

Go to Heater Blower Controls System Check

--

Repair the open in the BLK/WHT wire between the blower motor resistor and S200. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to Heater Blower Controls System Check

--