GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1362522  Size: SH
  1. Cycle the folding top to reveal the body accessory compartment.
  2. Turn the ignition switch to the OFF position.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

  4. Object Number: 1386454  Size: SH
  5. Loosen the nuts and remove the lid from the body accessory compartment.
  6. Remove the folding top control module. Refer to Folding Top Control Module Replacement .

  7. Object Number: 1390816  Size: SH
  8. Depress the retaining tab (1) and remove the rear electrical center from the intermediate bracket.
  9. Disconnect the electrical connector from the rear electrical center.
  10. Remove the rear electrical center for the vehicle.

Installation Procedure


    Object Number: 1390816  Size: SH
  1. Position the rear electrical center near the mounting location.
  2. Connect the electrical connector to the rear electrical center.
  3. Install the rear electrical center to the intermediate bracket ensuring the retaining tab (1) is fully seated.
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1386454  Size: SH
  5. Install the lid to the body accessory compartment.
  6. Tighten
    Tighten the nuts to 7.0 N·m (62 lb in).

  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  8. Close the folding top.