GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 SSR 🢒 Transmission/Transaxle 🢒 Shift Lock Control 🢒 Transmission Control Replacement

Removal Procedure
  1. Remove the front floor console. Refer to Console Replacement in Instrument Panel and Console.

    2. Object Number: 744173 Size: SH
  2. Disconnect the shift lock control solenoid wiring harness.
  3. Remove the end of the range selector cable (1) from the transmission control ball stud.
  4. Remove the range selector cable (2) from the floor shift control.

    5. Object Number: 745783 Size: SH
  5. Remove the transmission control bolts.
  6. Remove the transmission control.

Installation Procedure

    Object Number: 745783 Size: SH
  1. Install the transmission control.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the transmission control bolts.

    3. Tighten
    Tighten the transmission control bolts to 25 N·m (18 lb ft).


    Object Number: 744173 Size: SH
  3. Install the range selector cable (2) to the floor shift control.
  4. Install the end of the range selector cable (1) to the transmission control ball stud.
  5. Connect the shift lock control solenoid wiring harness.
  6. Install the front floor console. Refer to Console Replacement in Instrument Panel, Gages and Console.
  7. Check for proper operation of the floor shift control.
  8. Adjust the range selector cable if necessary. Refer to Range Selector Lever Cable Adjustment .