Removal Procedure
- Remove the left knee bolster. Refer to
Driver Knee Bolster Replacement
.
- Remove the right knee bolster. Refer to
Passenger Knee Bolster Replacement
.
- Remove the radio compensation microphone. Refer to
Radio Volume Compensator Interior Noise Microphone Replacement
.
- Remove 2 screws (1) that retain the data link
connector.
- Remove the 7 screws (1) to remove the bracket.
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install 7 screws (1) to secure the bracket.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
- Install 2 screws (1) that retain the data link
connector.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
- Install the radio compensation microphone. Refer to
Radio Volume Compensator Interior Noise Microphone Replacement
.
- Install the right knee bolster. Refer to
Passenger Knee Bolster Replacement
.
- Install the left knee bolster. Refer to
Driver Knee Bolster Replacement
.