GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Silverado - 4WD 🢒 Roof 🢒 Sunroof 🢒 Sunroof Housing Drain Gutter Replacement

Sunroof Housing Drain Gutter Replacement Extended Cab

Removal Procedure

    Important: Tape off the perimeter of the sunroof window opening before removing the sunroof module to prevent scratching.

  1. Remove the air deflector. Refer to Sunroof Air Deflector Replacement.
  2. Set the sunroof window to be in the open position of a minimum of 25 mm (1 in).

    3. Important: It is only necessary to lower the headlinder. Only do those steps in headlinder replacement that will lower the headlinder enough to grain access.

  3. Remove the sunroof module assembly.

    4. Object Number: 1825236 Size: SH
  4. Remove the screws (1) from the water gutter (2).

    5. Object Number: 1825238 Size: SH
  5. Slide the water gutter rearward to release the retaining tabs (1) from the slots (2) in the track.
  6. Remove the water gutter (3) from the track.

Installation Procedure

    Object Number: 1825238 Size: SH
  1. Position the sunroof water gutter to the sunroof window track.
  2. Seat the retaining tabs (1) on the water gutter (3) into the slots (2) in the track, and push the water gutter forward until the retaining tabs lock into place.
  3. Ensure that all 6 tabs are secured.

    4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1825236 Size: SH
  4. Install the water gutter screws (1).

    5. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  5. Install the sunroof module.
  6. Open the sunroof window to the fully open position.
  7. Install the air deflector. Refer to Sunroof Air Deflector Replacement.
  8. Remove the tape from around the perimeter of the sunroof window.
  9. Verify that the sunroof is operating properly.

Sunroof Housing Drain Gutter Replacement Crew Cab


Object Number: 2177984 Size: MF

Callout

Component Name

Preliminary Procedure

It is only necessary to lower the headliner. Only do those steps in the Headliner Replacement that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement

1

Sunroof Housing Drain Gutter

Procedure

  1. Only the remove the drain hose side that is being work on. Refer to Sunroof Housing Rear Drain Hose Replacement.
  2. Release the sunroof housing drain gutter clips located on the edge of the housing.
  3. Clean all of the old sealer from the drain gutter and the frame rail.
  4. Apply Kent Automotive High-Tech Clear Sealer (P/N P10200) 5 ounce tube or equivalent to the sunroof drain gutter on the path shown above.
  5. After installing the drain gutter, smooth out any sealer that may have squeezed out so there is a smooth transition between the gutter and the frame rail so water will not dam up or block the drain opening.
  6. Verify the drain gutter is fully engaged to the frame rail.