GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Tracker - 2WD 🢒 HVAC 🢒 HVAC Systems - Manual 🢒 Blower Motor Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Disconnect the blower motor electrical connector.
  3. Remove the PCM. Refer to Powertrain Control Module Replacement in Engine Controls - 2.0 L or to Powertrain Control Module Replacement in Engine Controls - 2.5 L.

    4. Object Number: 589695 Size: SH
  4. Remove 3 screws and the blower motor and fan (4) from the blower case.
  5. If necessary to remove the blower case, refer to Heater Case Replacement .

Installation Procedure

    Object Number: 589695 Size: SH
  1. Install the blower motor and fan (4) to the blower case. Secure the blower motor with 3 screws.
  2. Install the PCM. Refer to Powertrain Control Module Replacement in Engine Controls - 2.0 L or to Powertrain Control Module Replacement in Engine Controls - 2.5 L.
  3. Connect the blower motor electrical connector.
  4. Connect the negative battery cable.