Callout
| Component Name
|
Preliminary Procedures
- Remove the intake manifold cover. Refer to
Intake Manifold Cover Replacement
.
- Remove the drive belt. Refer to
Drive Belt Replacement
.
- Remove the drive belt idler pulley. Refer to
Drive Belt Idler Pulley Replacement
.
- Remove the power steering pump pulley. Refer to
Power Steering Pump Pulley Replacement
.
|
1
| Engine Lift Bracket Bolt (Qty: 3)
Notice: Refer to Fastener Notice in the Preface section.
Tighten 50 N·m (37 lb ft) |
2
| Engine Lift Bracket
|
3
| Power Steering Gear Inlet Pipe/Hose Fitting
Tip
• | Use an appropriate tool to remove the power steering fluid from the reservoir before removing the hoses from the pump. |
• | Use a new O-ring seal for installation. |
Tighten 27 N·m (20 lb ft) |
4
| Power Steering Pump Inlet Pipe/Hose
Tip Compress the clamp to disconnect the inlet hose from the power steering reservoir. |
5
| Power Steering Pump Bolt (Qty: 3)
Tighten 30 N·m (22 lb ft) |
6
| Power Steering Pump
Tip After installation, fill and bleed the power steering system. Refer to
Power Steering System Bleeding
. |