Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views DEFINITION: The CTD alarm does not disarm when using a key in any door or rear compartment lock cylinder. | |||
1 | Did you perform the Theft Deterrent Diagnostic System Check? | Go to Step 2 | |
2 |
Does the test light illuminate? | Go to Step 6 | Go to Step 3 |
3 | With the test light still connected, unlock the inoperative lock tamper switch with a key. Does the test light illuminate? | Go to Step 8 | Go to Step 4 |
4 |
Did you find and correct the condition? | Go to Step 11 | Go to Step 5 |
5 | Test for an open in the door lock tamper switch signal circuit. Refer to Testing for Continuity and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 7 |
6 | Test for a short to ground in the inoperative lock tamper switch circuit. Refer to Testing for Short to Ground and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 7 |
7 | Test for a poor connection at the inoperative door lock tamper switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 9 |
8 | Test for a poor connection at the RCDLR. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 10 |
9 | Replace the inoperative lock tamper switch. Refer to Front Side Door Lock Replacement in Door or Lock Cylinder Replacement - Rear Compartment Lid in Body Rear End. Did you complete the replacement? | Go to Step 11 | -- |
10 |
Important: Perform the program procedure for the ISU. Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement in Keyless Entry. Did you complete the replacement? | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |