• | Refer to Transmission Replacement in Automatic Transmission - 4L60-E. |
• | Refer to Transmission Replacement in Manual Transmission - NV 3500. |
Important: If replacing the engine flywheel (manual transmission), then NEW flywheel weights must be installed into the NEW engine flywheel in the same location as the old flywheel weights in the old engine flywheel.
Important: If replacing the engine flywheel (manual transmission), note the position and length of the original flywheel weights (if applicable). Flywheel weights of the same length must be installed into the new engine flywheel in the same location as the old flywheel weights were in the old engine flywheel.
A properly installed flywheel weight will be flush or slightly below flush with the face of the engine flywheel.
Align the engine flywheel locator hole to the flywheel locator pin.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the engine flywheel bolts in sequence (1-6) to 100 N·m
(74 lb ft).
• | Refer to Transmission Replacement in Automatic Transmission - 4L60-E. |
• | Refer to Transmission Replacement in Manual Transmission - NV 3500. |