GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Important: Mark, sort, and organize all the components for assembly.


    Object Number: 480526  Size: SH
  1. Remove the valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left Side or Valve Rocker Arm Cover Replacement - Right Side .
  2. Remove the valve rocker arms.

  3. Object Number: 480527  Size: SH
  4. Remove the valve rocker arm supports.

  5. Object Number: 480529  Size: SH
  6. Remove the valve pushrods.
  7. Clean and inspect the valver rocker arms and/or pushrods, if necessary. Refer to Valve Rocker Arm and Push Rod Cleaning and Inspection in Engine Mechanical - 4.3L Unit Repair.

Installation Procedure

Important: Be sure to keep parts in order. Parts must be reinstalled into the original location and position.


    Object Number: 480529  Size: SH
  1. Install the valve pushrods.

  2. Object Number: 480578  Size: SH

    Important: Be sure that the arrow on the valve rocker arm support is in the up position.

  3. Install the valve rocker arm supports.

  4. Object Number: 480551  Size: SH
  5. Apply lubricant GM U.S. P/N 12345501, Canada P/N 992704, or equivalent to the following valve rocker arm contact surfaces:
  6. • Valve pushrod socket (1)
    • Roller pivot (2)
    • Valve stem tip (3)

    Object Number: 480580  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the valve rocker arms as follows:
  8. 4.1. Finger start the bolt at location (1)
    4.2. Finger start the bolt at location (2)
    4.3. Finger start the bolt at location (3)
    4.4. Finger start the remaining valve rocker arm bolts

    Object Number: 334551  Size: SH
  9. Rotate the crankshaft balancer to position the crankshaft balancer alignment mark (1) 57-63 degrees clockwise or counterclockwise from the engine front cover alignment tab (2).
  10. Important: Once the valve rocker arms are installed and properly torqued, no additional valve lash adjustment is required.

  11. Tighten the valve rocker arm bolts.
  12. Tighten
    Tighten valve rocker arm bolts to 30 N·m (22 lb ft).

  13. Install the valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left Side or Valve Rocker Arm Cover Replacement - Right Side