GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 69450  Size: SH
  1. Disconnect the Negative Battery Terminal. Refer to Battery Cable in Engine Electrical.
  2. Remove the engine front cover. Refer to Engine Front Cover Replacement .
  3. Remove the crankshaft position sensor reluctor ring.

Installation Procedure


    Object Number: 69450  Size: SH

    Notice: Failure to properly align the crankshaft position sensor reluctor ring may result in component damage and effect OBD II system performance.

    Important: The reluctor ring is shaped like a dish.

    The dish must face the engine front cover. Failure to do so will damage the engine front cover and the reluctor ring.

  1. Install the crankshaft position sensor reluctor ring.
  2. Align the keyway on the crankshaft position sensor reluctor ring with the woodruff key (crankshaft balancer) in the crankshaft.
  3. Push the crankshaft position sensor reluctor ring onto the crankshaft until completely seated against the crankshaft sprocket.
  4. Install the engine front cover. Refer to Engine Front Cover Replacement .
  5. Install the Negative Battery Terminal. Refer to Battery Cable in Engine Electrical.